Race plate with Powerpod
Race plate with Powerpod
Got a long distance mtb race tomorrow, race number plate covers the powerpod..if I move PP mount to right/left bar is too narrow to clamp, I guess I could wrap duct tape/old intertube or something). Any suggestions?
Re: Race plate with Powerpod
Try to build up as much thickness as possible with stiff materials, perhaps the adapter ring that came with your Garmin bike computer...(your local bike shop might have something similar)
Whatever solution you try, make sure PP cannot rotate on the handlebars!
After moving PP, make sure to do a new O&B calibration ride.
Whatever solution you try, make sure PP cannot rotate on the handlebars!
After moving PP, make sure to do a new O&B calibration ride.
- Attachments
-
- IMG_0310.jpg (271.12 KiB) Viewed 2109 times
John Hamann
Re: Race plate with Powerpod
Thanks. I ended up using an old tire tube. Cut 1 inch wide and wrapped a couple feet and installed the mount kn it. It seems secure and tight. Glad I put my plate on today rather than tomorrow at the venue.
Re: Race plate with Powerpod
That will do the job!Scurby2 wrote:Thanks. I ended up using an old tire tube. Cut 1 inch wide and wrapped a couple feet and installed the mount kn it. It seems secure and tight. Glad I put my plate on today rather than tomorrow at the venue.
John Hamann