low Fric unable to update profile
Posted: Mon Aug 17, 2020 12:13 am
Hello all,
I did a training ride today, short bursts, and once finished PP gave me for the first 2 go's a far to high power value,
over 1300 Watts.
now i checked using 'Analyze - Check calibration' and it showed me that a correction would change the values significantly:
Original values:
Accepting calibration changes:
We can also see that the calibration changes are marked as very significant:
When I choose to send the profile to iBike, I receive the following error:
where is this discrepancy coming from?
I did a calibration ride, as lined out in the instructions: ride until power climbed to 50w, after ride the same way back.
I used it only on 1 bike so far.
everything else seems to be measured normal, but I can't upload the calibration changes since I checked the PP inside isaac after the initial calibration ride.
the original and corrected files are attached.
Please advise
I did a training ride today, short bursts, and once finished PP gave me for the first 2 go's a far to high power value,
over 1300 Watts.
now i checked using 'Analyze - Check calibration' and it showed me that a correction would change the values significantly:
Original values:
Accepting calibration changes:
We can also see that the calibration changes are marked as very significant:
When I choose to send the profile to iBike, I receive the following error:
where is this discrepancy coming from?
I did a calibration ride, as lined out in the instructions: ride until power climbed to 50w, after ride the same way back.
I used it only on 1 bike so far.
everything else seems to be measured normal, but I can't upload the calibration changes since I checked the PP inside isaac after the initial calibration ride.
the original and corrected files are attached.
Please advise