TT Bike Calibration

Post Reply
viniga
Posts: 35
Joined: Thu Jun 28, 2018 4:22 pm

TT Bike Calibration

Post by viniga »

Hi,

Just finished a calibration and a quick out and back ride on the TT bike after getting a second speed sensor. The out and back ride is attached. Oddly no 'cal' file was recorded. This was using the latest firmware. Can you check this calibration please? I note that the check calibration feature suggests a 'noticeable change'.

Should I be concerned that there was no 'cal' file?

And just to check, each bike now has a different speed sensor, so when riding PP will switch profile automatically, correct?

Many thanks for your support,

Vince
Attachments
outnbacktt_07_18_2018_2045_8_km_HiDef.ibr
(180.08 KiB) Downloaded 152 times
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: TT Bike Calibration

Post by Velocomp »

Your file is close to perfect!

As the latest firmware notes state, with FW 640 we have eliminated the "cal ride" file. It is not needed.

If your different bikes have different speed sensors, when you switch bikes PP should automatically change profiles.
John Hamann
viniga
Posts: 35
Joined: Thu Jun 28, 2018 4:22 pm

Re: TT Bike Calibration

Post by viniga »

Thanks John.

So I should I ignore the suggested change in the 'Check Calibration' feature?
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: TT Bike Calibration

Post by Velocomp »

Check calibration is intended for short, out-and-back routes. I would ignore it for this ride file.
John Hamann
Post Reply