powerpod on second bike, out and back cal ride fail
Posted: Mon Apr 16, 2018 9:16 am
Hello,
I successfully started the process to use my powerpod on my TT bike as a second bike. However when I got the place where I wanted to do the out and back, the battery in my speed/cadence sensor went flat!
Having replaced the battery now, I've spent some time today trying the get the powerpod into the same state again, this is what I've done:
from Isaac resent profile 2 (my TT bike), and then from isaac again set the "best accuracy" from the "setup device" menu, on both occasions I got the confirmation that the profile/settings had been sent to the device ok.
I've had the correct lights on the powerpod to show it's paired with the speed and cadence sensor, the same as in the video.
What's not happening though, is the correct lights for "ready for out and back cal ride". it's just a solid amber light.
I'd like to avoid riding for 10 minutes to do the cal ride, only to find it's not in the right mode, how can I be sure my powerpod is in the right state now or forcibly put it into the right state without touching profile 1?
cheers
Chris
I successfully started the process to use my powerpod on my TT bike as a second bike. However when I got the place where I wanted to do the out and back, the battery in my speed/cadence sensor went flat!
Having replaced the battery now, I've spent some time today trying the get the powerpod into the same state again, this is what I've done:
from Isaac resent profile 2 (my TT bike), and then from isaac again set the "best accuracy" from the "setup device" menu, on both occasions I got the confirmation that the profile/settings had been sent to the device ok.
I've had the correct lights on the powerpod to show it's paired with the speed and cadence sensor, the same as in the video.
What's not happening though, is the correct lights for "ready for out and back cal ride". it's just a solid amber light.
I'd like to avoid riding for 10 minutes to do the cal ride, only to find it's not in the right mode, how can I be sure my powerpod is in the right state now or forcibly put it into the right state without touching profile 1?
cheers
Chris