Page 1 of 1

Race plate with Powerpod

Posted: Fri Apr 13, 2018 11:44 am
by Scurby2
Got a long distance mtb race tomorrow, race number plate covers the powerpod..if I move PP mount to right/left bar is too narrow to clamp, I guess I could wrap duct tape/old intertube or something). Any suggestions?

Re: Race plate with Powerpod

Posted: Fri Apr 13, 2018 2:44 pm
by Velocomp
Try to build up as much thickness as possible with stiff materials, perhaps the adapter ring that came with your Garmin bike computer...(your local bike shop might have something similar)

Whatever solution you try, make sure PP cannot rotate on the handlebars!

After moving PP, make sure to do a new O&B calibration ride.

Re: Race plate with Powerpod

Posted: Fri Apr 13, 2018 3:25 pm
by Scurby2
Thanks. I ended up using an old tire tube. Cut 1 inch wide and wrapped a couple feet and installed the mount kn it. It seems secure and tight. Glad I put my plate on today rather than tomorrow at the venue.

Re: Race plate with Powerpod

Posted: Sat Apr 14, 2018 6:04 am
by Velocomp
Scurby2 wrote:Thanks. I ended up using an old tire tube. Cut 1 inch wide and wrapped a couple feet and installed the mount kn it. It seems secure and tight. Glad I put my plate on today rather than tomorrow at the venue.
That will do the job!