I'm in the process of adding a second bike in Profile 3. Today, I used the existing Profile 1 bike. Prior to the ride I asked Isaac to designate Profile 1 for the ride. PP has been paired to this bike for about a year. Upon start up today it displayed solid yellow asking for a calride, which I did. It seemed to progress and terminate normally, but then I got alternating green/red which I understand means its ready for an O & B calride. I did a successful O & B last June, the date of which is posted in Isaac as part of the Profile 1 label. I assumed it was still resident in the device until I got steady yellow this morning. As I have set up the Profile 3 bike, I have modified some of the info in Profile 1 assuming the existing O & B calride data from last year would not be affected. Would appreciate guidance.
Ride file from this mornings 5 minute calride is attached.
Thank You!
red green alternating lights
-
- Posts: 2
- Joined: Mon Apr 09, 2018 10:37 pm
red green alternating lights
- Attachments
-
- iBike_04_10_2018_1007_1_Miles_HiDef.ibr
- (36.66 KiB) Downloaded 206 times
Re: red green alternating lights
Here is what I understand:
1) You set up PP for an O&B calibration ride
2) You performed the ride.
3) At the end of the ride, the light still flashed red/green
If this is the case, then your O&B ride was unsuccessful, most likely because your PP was too far away from level. Make sure the word "PowerPod" is approximately level with the ground beneath it.
1) You set up PP for an O&B calibration ride
2) You performed the ride.
3) At the end of the ride, the light still flashed red/green
If this is the case, then your O&B ride was unsuccessful, most likely because your PP was too far away from level. Make sure the word "PowerPod" is approximately level with the ground beneath it.
John Hamann