Mounting position

Post Reply
Guido_K
Posts: 21
Joined: Fri May 13, 2016 8:40 am

Mounting position

Post by Guido_K »

Hey John,
the setup up of my aerobars and water bottle makes it difficult to use a standard mount. So I came up with a custom mount that will be permanentely attached to my aerobars using screws. Prior to drilling I would like to get your opinion if it is a good position for the PowerPod or if the shielding by the bottle is too much.

Unfortunately, the bends in the aerobars do not allow the PowerPod to be attached much out front.

Thank you,

Guido

P.S.: I am sorry for the low image quality. I hope it is still sufficient.
20180117_120348.jpg
20180117_120348.jpg (457.53 KiB) Viewed 2143 times
20180117_120315.jpg
20180117_120315.jpg (464.79 KiB) Viewed 2143 times
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: Mounting position

Post by Velocomp »

It looks like your PP is attached to the aero bars by two white zip strips. Is this correct?

The location is fine. You will just need to make the mount stiff such that the PP cannot vibrate.
John Hamann
Guido_K
Posts: 21
Joined: Fri May 13, 2016 8:40 am

Re: Mounting position

Post by Guido_K »

Thank you! The zip ties will be replace by a permanent mount which requires drilling my aerobars.
Post Reply