AeroPod, PowerPod and Newton

Help! I have FW5.x installed in my Newton. I had no problem with it until today when I loaded another Profile. (Profile 4). I originally have 3 profiles in Newton. The new 4th profile is the same bike as profile 1 but different wheelset. Before heading out, I set up profile 4 Via Isaac. I selected "good accuracy" for starters until I get to my Cal ride area where I did a proper Cal ride for the bike. I did the Cal ride procedure and Newton displayed Cal ride done so I went and ride my regular ride. After a few minutes, I notice that my power # seem off. I went to set up and the profile was switched to 1. When I switched to profile 4 and go back to normal screen, The middle display is telling me to do another Cal ride. What!? I just did one and it was good. I finished my ride and open Isaac. Open edit profile and it showed the cal ride I did. I sent it to Newton as profile 4 but Newton kept telling me to do a Cal ride even if Cal ride was done for the profile and after being loaded by Isaac. Maybe a bug?

I got stuck not being able to get the thing out of the "cal" mode. It was raining and has for days, and I didn't couldn't get out of that screen. It was frustrating, I just wanted to play around and get familiar with it.