Queries Related to Powerstroke on Powerpod
Posted: Tue Nov 29, 2016 11:54 am
Hi,
I have just purchased the powerstroke upgrade for my powerpod in blackfriday deal. After going through the instruction i have installed the Powerstroke upgrade key which was sent by Mr.Tom Gore into my PP and when i access the Device > Unlock Feature> Get unlock status , I get this screen saying Powerstroke is installed So i know it is installed...But it says Newton powerstroke and not powerpod powerstroke is it ok? I am asking this because i happened to see a Powerstroke upgrade only for newton listed in website. so i wanted to be sure.
I went ahead and read the instruction in isaac regarding powerstroke and it only lists the powerpod instruction pertaining to newton and not on powerpod. I also tried to access the video on the powerstroke upgrade page for powerpod but the site it gets directed says its forbidden. enclosing a screenshot
So i have a few queries as usual.
1. How do i know if my PP is in Powerstroke recording mode enabled?
2. How can i switch off the powerstroke recording mode if i go for a long ride above 6.5hrs?
3. Should i go for a calibration ride again or something?
4. Since i use a garmin magnetless sensor what setting should i choose in my cadence sensor position?
These are listed in instruction pertaining to newton but since PP is a standalone gadget i dont know how to do this?
Please help
Drashkum
I have just purchased the powerstroke upgrade for my powerpod in blackfriday deal. After going through the instruction i have installed the Powerstroke upgrade key which was sent by Mr.Tom Gore into my PP and when i access the Device > Unlock Feature> Get unlock status , I get this screen saying Powerstroke is installed So i know it is installed...But it says Newton powerstroke and not powerpod powerstroke is it ok? I am asking this because i happened to see a Powerstroke upgrade only for newton listed in website. so i wanted to be sure.
I went ahead and read the instruction in isaac regarding powerstroke and it only lists the powerpod instruction pertaining to newton and not on powerpod. I also tried to access the video on the powerstroke upgrade page for powerpod but the site it gets directed says its forbidden. enclosing a screenshot
So i have a few queries as usual.
1. How do i know if my PP is in Powerstroke recording mode enabled?
2. How can i switch off the powerstroke recording mode if i go for a long ride above 6.5hrs?
3. Should i go for a calibration ride again or something?
4. Since i use a garmin magnetless sensor what setting should i choose in my cadence sensor position?
These are listed in instruction pertaining to newton but since PP is a standalone gadget i dont know how to do this?
Please help
Drashkum