Page 1 of 1
stages pm with newton
Posted: Mon Feb 22, 2016 11:32 am
by ianusy2k2
Is stages compatible with Newton?
Re: stages pm with newton
Posted: Mon Feb 22, 2016 11:59 am
by Velocomp
Yes; Newton will read Stages power readings
Re: stages pm with newton
Posted: Mon Feb 22, 2016 9:24 pm
by ianusy2k2
Doing a scan of Ant sensors will automatically detect the DFPM? How will you know if Newton is showing the DFPM values? I'm trying to switch DFPM display on/off by following the manual
Re: stages pm with newton
Posted: Tue Feb 23, 2016 4:32 am
by Velocomp
Yes, doing a Scan of ANT+ sensors will automatically find the Stages (or other) DFPM.
After a Scan, by default the Newton displays the DFPM readings ("On dFP diSP"--DFPM display is on). If you prefer to display the Newton power readings on your screen, then enter Setup (press-hold the center button until "setup" appears). Click the down arrow until "On dFP diSP" appears. Click the center button. "On" flashes. Use the bottom arrow to select flashing "Off dFP diSP". Click the center button to accept' "done" flashes. Press-hold the up arrow to exit setup.
Re: stages pm with newton
Posted: Wed Feb 24, 2016 8:58 am
by ianusy2k2
Thanks for the reply... One last question... Do I need to do calibration again
Re: stages pm with newton
Posted: Wed Feb 24, 2016 10:07 am
by Velocomp
No recalibration of your Newton is required.