Page 1 of 1
Wind cal changed in middle of the ride
Posted: Sat Feb 13, 2016 2:15 pm
by still-chasing
During my ride today, noticed a sudden change/loss of power about halfway. It's a misty morning. I just let it go hoping the computer will correct itself. About 7 miles before home, I finally can't help it so I stopped and checked the "set up". Wind Cal was VERY HIGH. Blew air in the port to blow out any blockage if any and then click Wind Cal to reset to zero. But every time i click, the number stay high or sometimes negative. I then did a trip reset and did the same. "wind cal" numbers stayed high. I merged the 2 files together.
Thanks!
Re: Wind cal changed in middle of the ride
Posted: Tue Feb 16, 2016 9:11 am
by still-chasing
How do I repair the bad file I mentioned above. Thanks!
Re: Wind cal changed in middle of the ride
Posted: Tue Feb 16, 2016 11:31 am
by Velocomp
It looks like the mist blocked your wind sensor. If you ride often in these conditions it's time to upgrade to a Newton 6!!
I used the Tools/Repair Selection for Blocked Wind Sensor... command to get your file back to normal. Highlight the bad wind data then apply the command.
Repaired ride file is attached.
Re: Wind cal changed in middle of the ride
Posted: Wed Feb 17, 2016 12:36 am
by still-chasing
Thank you.