power pod calibration question
Posted: Fri Dec 23, 2016 8:25 am
Hi i am an absolute newbie to power and power pod.I have not touched the iaasc software. I have tried to calibrate my power pod but values are wrong as i had a lactate test done and values on my garmin 500 were way off what the test showed.
On my Garmin, speed/cadence sensor 52132 connected,power meter connected 26679.
So when i start up i spin wheel/crank to awaken sensors,press pp goes green then goes out.I turn on Garmin says do u want to calibrate pp yes/no,i press yes ,it says cal successful _ _ 0_ _ shows on screen.(i tried riding with this nothing happens)
PP does not flash does not do anything,when i go out riding the power shows up on normal screen but figures are wrong.
what am i doing wrong i'm at a loss any help much appreciated.
On my Garmin, speed/cadence sensor 52132 connected,power meter connected 26679.
So when i start up i spin wheel/crank to awaken sensors,press pp goes green then goes out.I turn on Garmin says do u want to calibrate pp yes/no,i press yes ,it says cal successful _ _ 0_ _ shows on screen.(i tried riding with this nothing happens)
PP does not flash does not do anything,when i go out riding the power shows up on normal screen but figures are wrong.
what am i doing wrong i'm at a loss any help much appreciated.