Repeat Profile following Stem change

Post Reply
faheyb
Posts: 21
Joined: Tue Nov 30, 2010 1:54 am

Repeat Profile following Stem change

Post by faheyb »

I have run my Newton on two similar bikes for 18 months or so and have been reasonably happy with the profiles. Recently I went through a bike fit , following a ski injury, and will now need a slight change to my stem angle (the only significant change was a 2 deg increase in rise, same bars) Is it acceptable to refit the Newton on the stem again and recalibrate via a short ride out/back followed by a check calibration, or completely re-do each profile.
TriBike
Posts: 70
Joined: Sat Jul 02, 2011 9:27 am

Re: Repeat Profile following Stem change

Post by TriBike »

Since nothing has changed with the weight of the bicycle, and it is just a change in the mounting of the Newton, I think you will be fine just doing a new Cal Ride procedure.
Post Reply