Average and actual watts

Post Reply
JoseJ
Posts: 51
Joined: Sun Sep 08, 2013 5:11 pm

Average and actual watts

Post by JoseJ »

Hello. Is there a way to see average and actual watts on the same screen at tge same time when doing intervals without pourchasing the key that sends watts to garmin?
I would like to buy it but 99€....uffff...!!!
Thank you very much
Pete
Posts: 110
Joined: Wed Mar 05, 2014 8:09 am
Location: Melburn, AUS

Re: Average and actual watts

Post by Pete »

Form page 37 of Newton Instructions:
Suppose you’re going to do a time trial; the time trial can be thought of as one huge
interval. The Newton gives you a way to manage your time trial so you can see average
watts, actual watts, and elapsed time, all on the same screen. Here’s how:
1: Enable the Fit Train feature in the User Sequence (Setup/User/Yes/Fit Trn On)
2:While in the main screen, press-hold the right arrow to enter FIT TRAIN.
Use the left/right arrow to select “USER”:
2. Click the center button to enter the User Interval.
3. To start the first User Interval, click the center button or just start pedaling;
when you start moving the User Interval will start automatically.
3. You’ll see average watts in the top window, actual watts in the middle screen, and
elapsed time in the bottom window.
NOTE: IN THE TOP WINDOW THE LEAST SIGNIFICANT DIGIT OF THE AVERAGE WATTS
NUMBER WILL BE SUBSCRIPTED. FOR EXAMPLE, AN AVERAGE WATTAGE OF 198W WILL
SHOW IN THE TOP WINDOW AS 198
4. To end an interval, click the center button. The prior user interval will stop and a
new user interval will begin immediately
* I am hoping a future upgrade might allow NP and also W'bal in a mode similar to this
JoseJ
Posts: 51
Joined: Sun Sep 08, 2013 5:11 pm

Re: Average and actual watts

Post by JoseJ »

Thank you
really helpfull
Post Reply