New Setup

Post Reply
dgf
Posts: 20
Joined: Tue Jun 26, 2012 8:11 pm

New Setup

Post by dgf »

Went with new bar set up and just no way the Newton was going to see clean air without using RWS. Did some pondering and came up with this setup:

Image

Image

Seems decently clean, simple, should see good air. Will try Cal Ride tomorrow.
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: New Setup

Post by Velocomp »

Looks good! Please post a ride file!
John Hamann
dgf
Posts: 20
Joined: Tue Jun 26, 2012 8:11 pm

Re: New Setup

Post by dgf »

Seems like it works OK. Maybe a little windy for a Cal Ride but data looks OK to me...??? Attached Cal Ride and little loop I did a couple times.

Used two of these for the set up - pretty simple:
http://www.amazon.com/Profile-Design-Un ... uter+mount
Attachments
iBike_04_12_2013_1712_13_Miles.ibr
(226.07 KiB) Downloaded 511 times
Cal Ride 4-12.ibr
(34.33 KiB) Downloaded 506 times
Velocomp
Velocomp CEO
Posts: 7793
Joined: Fri Jan 11, 2008 8:43 am

Re: New Setup

Post by Velocomp »

dgf wrote:Seems like it works OK. Maybe a little windy for a Cal Ride but data looks OK to me...??? Attached Cal Ride and little loop I did a couple times.

Used two of these for the set up - pretty simple:
http://www.amazon.com/Profile-Design-Un ... uter+mount
Your cal ride looks great but your 13 mile ride is odd, for two reasons:

1) your CdA is different from your Cal Ride, and is set to road-bike value. Did you change it? If so, why

2) It looks like you have strong tail winds in part of your ride. Is this correct?
John Hamann
Post Reply