Calibration Ride Failed

[dabaracus]

I have updated the firmware and have done a hardware reset on my new iPro wireless, so i went to do a calibration ride, and after i got back, i got calibration fail message. I tried 3 times over the same course, one after each other and i got the same result, i re-did the tilt and wind offset, both successfully each time. However i cant get the calibration ride to pass.

Any Ideas?

[coachboyd]

Can you post a solo ride on here where you started and ended at the same place? I want to see if maybe your wind scaling is out of the acceptable range.

[dabaracus]

sorry for the delay, have been realy busy with work. I have uploaded a 20km ride and one of the calibration rides

[dabaracus]

no response?

[Velocomp]

Something is wrong with your wind sensor readings and it needs to be looked at. Please send it to us.

Note that your iBike is nearly two years old.

[dabaracus]

Thanks for the reply, 2 things
- how do i get the wind sensor readings?
- i bought this from a bike store in june this year....

Dave

[dabaracus]

I have managed to get the calibration done and have done 10 cost downs, numbers seem to fit better. I checked the wind sensor and there was nothing stuck in there, i got some Air in a can and gave it a clean, Last nights ride showed wind reading that seemed more realistic, and it was the first ride that hasnt asked if i was drafting, when i never draft as i only ride solo.

Dave