AeroPod, PowerPod and Newton

I just got my repaired unit back today, new case but now I'm getting WLS FAIL. I did a search of the forum and tried doing a hard reset on everything by reversing the batteries (unit, mount, sensors) but no luck. This is a new mount too, for bike 2. I tried the iBike on bike 1, worked fine. Is there anything else I can try?

Thanks.

Sounds like the iBike, itself, is working.

With the iBike on the mount for bike 2 and both bikes close together - will the iBike pair with the bike 1 sensors?

Check the batteries in the sensors on bike 2 and the mount on bike 2.

Tom

I put new batteries in the bike 2 mount and sensors still no wireless. I tried to cross pair from bike 2 to bike 1, and the other way with the iBike on bike 1, neither would work, it only pairs when on bike 1 set to Prof 1. If just the mount 2 was faulty I would have expected it to pair when on mount 1 with bike 2. Good idea - thanks.

Just wanted to update this thread. I tried my iBike again on bike 2 last night and it paired up fine. I think the problem may have been water, I drove to a race last weekend with the bike on the roof, and went through a horrendous storm. I'm wondering if that could have caused issues with the mount and the sensors. However I did not see any signs of moisture when I changed all the batteries. The fact that it took some time and righted itself makes me suspect water though.