Pairing issue
Posted: Mon Jan 04, 2010 8:49 am
I have a pairing issue with my Gen III iAero and can't solve it.
If the unit goes unused, either between rides or goes to sleep during a break in a ride, it loses pairing and will not recover it until I reload the profile that contains the respective sensor IDs. I then have to start pedaling, enter setup and click on scan. It is only then that the sensors are found. This occurs on any of my 3 different mounts/bikes. I loaded the newest firmware this weekend and the problem continues. If I go into the setup mode at any time after I start riding the "scan" screen will indicate "no." Furthermore, I can't access any other profile than "0."
In comparison, I still use my Gen II unit (because the pairing is more reliable), I start pedaling, hit the center button and in 2-3 seconds the SPCD Found indicator lights up and I am on my way. This happens the same on any of my mounts/bikes.
If the unit goes unused, either between rides or goes to sleep during a break in a ride, it loses pairing and will not recover it until I reload the profile that contains the respective sensor IDs. I then have to start pedaling, enter setup and click on scan. It is only then that the sensors are found. This occurs on any of my 3 different mounts/bikes. I loaded the newest firmware this weekend and the problem continues. If I go into the setup mode at any time after I start riding the "scan" screen will indicate "no." Furthermore, I can't access any other profile than "0."
In comparison, I still use my Gen II unit (because the pairing is more reliable), I start pedaling, hit the center button and in 2-3 seconds the SPCD Found indicator lights up and I am on my way. This happens the same on any of my mounts/bikes.