Newton Instructions, FW 4 and prior

[Velocomp]

Detailed iBike Newton Instructions for Newton FW 4 and prior, updated August 9, 2014. Detailed Index of Topics has been added at the end of the document.

[Velocomp]

To do a hard reset, press-hold the bottom, right, left, and center keys simultaneously.

[talaskgg]

My Newton will not leave the setup page. Depressing the top key while in it causes the words setup to appear again.

[Velocomp]

My Newton will not leave the setup page. Depressing the top key while in it causes the words setup to appear again.

Please do a hard reset and see if that fixes the problem.

[talaskgg]

Yes, a hard reset did the trick

[tdriscoll]

photo-1.JPG (120.93 KiB) Viewed 19305 times

I am at my wit's end... I have entered basic information (i.e. weight, height, alt, etc.) and completed the "tilt"; however, I am unable to complete the scan. The only item that will scan is my Garmin heart rate belt. Does anyone have any suggestions? I keep on getting a "Speed Error" message. Enclosed, please find three pics. Pic # 1 shows "Cadence Set-up Option # 1. Pic # 2 shows "Speed Magnet to Magnet Set-up" and Pic # 3 shows "Cadence Set-up Option" # 2.

[Velocomp]

The spoke magnet needs to pass within 1-2 coin widths of the vertical notch in the rectangular speed sensor. It's unclear from your photos if this is the case.

Please give us a call and we will help you sort things out.

[ronpei]

one small edit I have seen so far, on page 22 the step 7 is missing the word tilt inside the quotes.

[Velocomp]

one small edit I have seen so far, on page 22 the step 7 is missing the word tilt inside the quotes.

Got it!