AeroPod, PowerPod and Newton

Here is the bike

http://s33.postimg.org/nrdncg31r/look_695.jpg

Close up of handlebar

http://s33.postimg.org/emxbceovj/look_c ... bars_2.jpg

Unfortunatly it doesn´t look like that so is there maybe some kind of gopro mount that would work?

Is there any mount out there that could work with an road aerobar like these?

https://cyclepathpdx.com/wp-uploads/201 ... Detail.jpg

A verry flat bar.

Hi John Found the fault :) Did the hardreset and put the bike on a parkingstand and spunn the wheel.. wtf no speed, aha changed the wheel the other day and the spoke magney was missaligned !! moved the magnet about 2mm and then it started to show speed and the calibration process started :) rode the...

Was just out testing it again but still can´t get it to start the calibration Here is a small and windy youtube video that I made after first riding for about 8-10 minutes without any sucess https://youtu.be/55CFYFhlDY4 In the video it looks like it changes colour but that must be something with the...

The firmware is 6.10 according to Isac software

Thanks John
I will give it a try this afternoon, have had the PP on charge over night
But if this not work is there a way in the Isac software to do a factory reset of the PP ?

Hi Just recieved my powerpod and have a question about the setup - Charged the battery until the red lamp went out - woke the garmin GSC-10 sensor - Sets the powerpod in pairing mode takes just a few seconds for it then a steady green light for maybe 30 sec then it turns steady yellow - Starts my ga...